All hobbies › Eraser Stamp Carving
Eraser Stamp Carving 消しゴムはんこ
A hobby where you carve an eraser with a cutter to make a one-of-a-kind stamp (keshigomu hanko).

- Cost
- From ¥500; up to ¥10,000 if you get serious
- Time
- Once a week, 1 hour or more
- First step
- Carve a simple circle on an eraser
Why people love eraser stamp carving
Transfer a pencil design onto the surface of an eraser and shave away the outside of the lines with a cutter, and the remaining lines become a stamp. Press it on paper, and the small picture you drew shows up crisp, like a seal. It is also fun that it has many uses: stamping it on a letter seal or lining up cats on the edge of a notebook. Once you carve one, you can use it again and again right away. Stamping it casually on the edge of a notebook or letter conveys handmade warmth. Made into New Year cards or personalized gifts, one stamp makes a special piece.
How to start
- Choose an easy-to-carve special eraser (about ¥200) and a simple 1 cm design
- Prepare an eraser, a design knife, a pencil, and an ink pad
- Trace the design with a pencil, carve it, stamp it on paper, and check how it came out
What you need
- Must have: An easy-to-carve eraser, a cutter or carving knife, a pencil, an ink pad
- Nice to have: Tracing paper, a V-shaped carving tool, spare blades, a cutter mat
- Not needed at first: Expensive special rubber, large tools
From beginner to advanced
- BeginnerUp to ¥1,000
Next challenge: Lines get thick and the design gets crushed
- Intermediate¥1,000–¥3,000
Next challenge: Carving while leaving fine lines is difficult
- AdvancedFrom ¥3,000
Next challenge: The block positions do not match in multicolor printing
Tips
- Rather than drawing the design directly on the eraser with a pencil, transfer it from paper so it is flipped. When carving letters, the basic rule is to transfer them in a mirrored form. This step is especially important when letters are included.
- Before carving, trace the surface you will not carve with your finger to check. A habit of not mixing up the parts you keep and the parts you remove greatly reduces the mistake of cutting the wrong surface.
- Before pressing on the ink pad, try a test stamp on the edge of a paper. Checking the amount of ink and the pressure beforehand avoids failures. Checking the paper and the force first gives peace of mind.
FAQ
How old do you have to be?
From upper elementary school age. Since you use a cutter, for lower grades an adult should help with the cutting parts.
Can I do it alone?
Yes. Carving with friends at a workshop widens your ideas for choosing tools and designs.
How much does it cost?
You can start from about ¥500 with an eraser and a cutter. Even adding a special carving knife and an ink pad, it stays within a few thousand yen.
Can I do it if I am bad at drawing?
Start with simple shapes and you will be fine. Designs with simple outlines like circles and stars turn out neat even for beginners.
Is the cutter scary?
Keep the blade short and do not put your hand in the cutting direction. Work on a desk, and retract the blade when you finish and put it away.
Similar hobbies
Costs and steps are typical examples in Japan and can vary. 日本語のページ